Cycle Pal Installation Instructions

Cycle Pal is a 1-hour timer for motorcycles. When the ignition switch is turned off, it begins timing. After an hour, it turns off the connected loads. When the ignition switch is turned on, Cycle Pal resets and re-energizes the electrical loads. Cycle Pal handles a 12-amp continuous load and draws only 70 millionths of an amp in stand-by. This feature ensures Cycle Pal fully protects your battery.

Mount Cycle Pal using the provided Super Velcro (or screws in the holes of the box feet). The mounting surface must be dry and free of oil and dirt. The adhesive takes several hours (overnight is best) to fully cure.

For wiring, use only high quality crimp connectors:
• Red connects to Battery Positive
• Black connects to Battery Negative (The 2 black wires allow for insertion into a loom.
• Orange connects to your electrical equipment. This could be radio, radar, strobe, etc.
• YELLOW connects to any circuit that is "hot" when the ignition is either on or in accessory position.