Copeland Engineering

Dock Master Installation Instructions

Hardware

Dock Master is installed using the standard Copeland Engineering wire color codes. Remove the fuse until all voltage connections are completed.

  1. The BLACK wire must connect to a good ground.
  2. The RED wire is fused with a 10-amp automotive minifuse. It is connected to the vehicle electrical system.
  3. The ORANGE connects to the computer DC power supply or to the docking station DC power input.
  4. The YELLOW connects to any circuit that is "hot" when the ignition is either on or in accessory position. This turns Dock Master on immediately with the ignition and overrides the voltage sensing for engine off. It does NOT override the dead battery detection system. (vehicle voltage is less than 10.5 volts for 30-seconds.)
  5. Reinstall the fuse and connect the USB cable between the Dock Master Switch and the computer.
  6. Start the vehicle. The Dock Master will turn on.
Software

Dock Master PC software is provided on a CD-ROM. It is a self-extracting installation. Once installed, it will start during the computer boot sequence. Windows XP or 2000 with service pack 3 is required.
Operator screen appears 5 minutes prior to shutdown. This allows the operator to add time via the snooze button if they are still working in the vehicle. It can also be brought up by right-clicking the Copeland logo in the task bar.

The "Configure" button on the operator screen opens the time configuration screen. This is where the delay time values are changed.

The "Configure Switch" button leads to the voltage configuration parameters. These values should only be adjusted by a qualified technician


Return to: